Farm to Table Apron
Turn a basic dishtowel into a perfectly practical, and fully adjustable, apron in a few simple steps. Stitch the embroidery, create a casing, run the ribbon and it is Ta-Done! This Farmhouse Apron is the perfect accessory for baking a fresh fruit pie and always a welcomed gift for everyone who gets their hands dirty now and then. The Farm to Table collection boasts a bounty of inspiration to appreciate the simple things in our daily life.
- Farm to Table design #12774-06
- Ultra Clean and Tear Fusible
- StitcH2O Topping
- Large dishtowel (prewashed and pressed)
- 5/8" wide grosgrain ribbon for neck strap and tie
- Isacord Thread
Fold the towel in thirds lengthwise. Press creases down to the horizontal center.
Fold the towel in half lengthwise and press a crease to mark the center of the towel without removing the creases created in Step 1.
Open out the towel, wrong side up, on an ironing surface. Fold the top corner of the towel from the outer crease to the center crease at an angle. The bottom of the angle should be the horizontal center of the towel. Press.
Repeat step 2 for the opposite side.
Open the towel and mark 1” from the diagonal lines toward the corners.
Fuse two layers of Ultra Clean and Tear Fusible, one at a time, at least 2” larger than the hoop size over the design area on the back of the towel.
On the right side of the towel mark a vertical line down the center front and a horizontal line 6” from the top of the towel.
Hoop the towel aligning the marks on the towel with the marks on the hoop or hoop template.
Move the hoop to align the design crosshair with the needle in the center of the design.
Cover the design area with StitcH2O, tape in place if desired. Stitch the design. When complete, remove excess stabilizer by tearing away from the design area. It is not necessary to remove all traces of Ultra Clean and Tear Fusible since remnants will go away with laundering.
Trim off the corners of the towel marked in Step 4 and use overlock stitch to finish the raw edge or use a serger or overlock machine. Fold back in place at the fold line and press to flatten.
Close the casing by stitching 3/4” from the folded edges of each side of the apron.
Use Alligator Clamps, a bodkin or your favorite method for feeding a single length of ribbon through the casing. Start at one of the lower sides going up and out at the next then down the next side.
Pull through enough ribbon to be able to tie it in the back.
And that's it! This would make a great project for the kids to help with.
This material is © OESD, LLC and may not be reproduced or published without permission.